Wired Intelligent Edge

 View Only
Back to discussions
Expand all | Collapse all

1960 config to route Subnet to other Subnet

This thread has been viewed 5 times

  • 1.  1960 config to route Subnet to other Subnet

    Posted Aug 08, 2023 01:04 PM

    Good afternoon gents, 

    I am in need of help to figure out how to configure the instant on 1960 for the following:

    1. Network 1 connected to port 25-26 is the link to the internet, sitting on Subnet 192.168.233.0/24
    2. Network 2 is the one I need to build on the Switch. Subnet 192.168.100.0/24 Port 1-24+27-28. Traffic needs to be routed to Network 1 for internet access.
      the 1960 needs to provide DHCP, which is configured to 192.168.100.101-199. Gateway will be the Switch as well.

    I have tried it with 2 different vlans and a static route but the GUI of the Aruba instant is new for me and I am used to configure networks on command lines and not through a very clicky clicky GUI.
    Hence why I need your help to figure it out. 

    I've tried so many different things in GUI that I am at my wits end.

    Would really appreciate it.

    KR

    Sacha



  • 2.  RE: 1960 config to route Subnet to other Subnet

    Posted Aug 09, 2023 04:56 AM

    Please ask this question on the Aruba InstantON forum.



    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------

    Original Message


Related Content