Thank you for that document.
I ran the show ap debug port status ap-name AP-xy on the controller and it returned forward mode as tunnel. In my config it was configured for bridge. I made a new profile from scratch (since I had used the default profile, never use the default profile) and now it returns bridge in forward mode and everything is fine :-)
Thx a lot for your help.
/Fredrik
------------------------------
Fredrik Lehmann
------------------------------
Original Message:
Sent: Mar 31, 2022 04:28 AM
From: Stefan Bartels
Subject: 303P-Daisy chain
Yes that is the wired Profile but is it also bind to the interface?
That´s why I asked for the config. This is just a small snippet of the puzzle.
do you know that document - https://higherlogicdownload.s3-external-1.amazonaws.com/HPE/2dc2fcfc-9652-4973-8648-683e56483f3b_file.pdf?AWSAccessKeyId=AKIAVRDO7IEREB57R7MT&Expires=1648718615&Signature=so9Jn9%2BixcFLt02uxj4f4ZKkcD0%3D
Original Message:
Sent: Mar 30, 2022 03:24 PM
From: Fredrik Lehmann
Subject: 303P-Daisy chain
------------------------------
Fredrik Lehmann
Original Message:
Sent: Mar 30, 2022 12:33 PM
From: Stefan Bartels
Subject: 303P-Daisy chain
Can you upload the anomynized config to have a look into?
Original Message:
Sent: Mar 29, 2022 07:45 AM
From: Fredrik Lehmann
Subject: 303P-Daisy chain
Hi!
After upgrade from AOS 8.7.1.6 to 8.7.1.8 my ap which are connected through eth1 on my 303p daisy chain can't get an IP address any more. The configuration is the same.
The daisy chained ap is bridged out on local vlan.
Any suggestions?
Best Regards
Fredrik Lehmann
------------------------------
Fredrik Lehmann
------------------------------