Hi all,
I just recognized that some switches have checksum issues.
When I enter the "save" command and save the configuration the switch tells me that Unit1 was successfully saved but Unit2s and Unit3s checksum is different from Unit1s and therefore, I think the it doesn't get saved correctly.
I already checked if there would a difference between the units in the configuration but it absolutely looks the same (except the client ports of course).
Currently I'm using this Firmware: V3.03.02s168p21
I was looking for a solution in the Internet but only found the same question with no real answer.
And if I found an answer, I tried it but it was not successful (for ex re-adding cipher commands).
Does someone know how to fix this without a firmware update?
Thank you,
Remo
P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. -HP Forum Moderator