Wired Intelligent Edge

Hi,

If I replace a member switch in 6300M series stack, will the new member (same part) receive automatic config from the master OR do I need to load the running config in the new member switch upfront and install in the stack?

Also, If the member has the lower version os, will it be fetch from the master once it join to the stack or do I need to prepare the new member with the same os as master before install into the stack? 

Thank you for the support.

------------------------------
Chirag Patel
------------------------------

the firmware image will automatically sync across the VSF stack.
check this guide.
https://www.arubanetworks.com/techdocs/AOS-CX/10.06/HTML/5200-7726/index.html#GUID-3F677E8E-0C4C-4A10-A8F2-9306AD8C45C1.html

------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
------------------------------

Original Message:
Sent: Feb 21, 2021 09:55 PM
From: Chirag Patel
Subject: 6300M member replacement

Hi,

If I replace a member switch in 6300M series stack, will the new member (same part) receive automatic config from the master OR do I need to load the running config in the new member switch upfront and install in the stack?

Also, If the member has the lower version os, will it be fetch from the master once it join to the stack or do I need to prepare the new member with the same os as master before install into the stack? 

Thank you for the support.

------------------------------
Chirag Patel
------------------------------

Thanks, Ariyap.


------------------------------
Chirag Patel
------------------------------

Original Message:
Sent: Feb 21, 2021 10:04 PM
From: Ariya Parsamanesh
Subject: 6300M member replacement


the firmware image will automatically sync across the VSF stack.
check this guide.
https://www.arubanetworks.com/techdocs/AOS-CX/10.06/HTML/5200-7726/index.html#GUID-3F677E8E-0C4C-4A10-A8F2-9306AD8C45C1.html

------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.

Original Message:
Sent: Feb 21, 2021 09:55 PM
From: Chirag Patel
Subject: 6300M member replacement

Hi,

If I replace a member switch in 6300M series stack, will the new member (same part) receive automatic config from the master OR do I need to load the running config in the new member switch upfront and install in the stack?

Also, If the member has the lower version os, will it be fetch from the master once it join to the stack or do I need to prepare the new member with the same os as master before install into the stack? 

Thank you for the support.

------------------------------
Chirag Patel
------------------------------