Wired Intelligent Edge

Hi,

I'm new for 6300 CX OS.

On the VSF best practice document, it mention can trunk 4 DAC cables for 200G if only have two members.

But it didn't show how.

I'm not sure just use this command "link 1 int 1/1/49-1/1/52" will do it, or I need configure other LAG group commands to bind those 4 ports for VSF between master and standby ?

Thanks

Hi!

---

@Peipei wrote: I'm not sure just use this command "link 1 int 1/1/49-1/1/52" will do it, or I need configure other LAG group commands to bind those 4 ports for VSF between master and standby ?

Yes, it will do.

The command link <link-id> [<ifrange>] creates or modifies a VSF link (the VSF Link id specified by the <link-id> parameter). The physical interface(s) that make up the VSF Link can be specified through this command by using the <ifrange> parameter. So link 1 1/1/49-1/1/52 will create the VSF Link 1 made of ports 1/1/49, 1/1/50, 1/1/51 and 1/1/52.

Have a read ArubaOS-CX Virtual Switching Framework (VSF) Guide for Aruba 6200 and 6300 Switch Series (May 2020, Edition 5), this guide plus the VSF Best Practice Guide you already read are the foundation to correctly setup and manage a VSF deployed using ArubaOS-CX based switch series (either by using Aruba CX 6200 or by using Aruba CX 6300F/M).

Thanks, Will do.