Cloud Managed Networks

Hi all,

I want to read some configuration, which is normally hidden in the config, like the RADIUS shared secret or the WPA PSK. 

In AOS8 you could "encrypt disable" and then these are shown in the CLI for the running session. 

On 9012 gateways running 10.4.0.2 this is no longer possible and gives the error, that the command is only possible in support mode. 

Support mode can nly be enabled by TAC because you need an HPE mail to create the support token. 

On 9240 gateways running 10.4.0.2 this command still works.

What is the correct way to read these information on 9012?

try this "show run no-encrypt"

------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.

Original Message:
Sent: Sep 13, 2023 04:04 AM
From: bkohnke
Subject: AOS 10.4 gateway encrypt disable

Hi all,

I want to read some configuration, which is normally hidden in the config, like the RADIUS shared secret or the WPA PSK. 

In AOS8 you could "encrypt disable" and then these are shown in the CLI for the running session. 

On 9012 gateways running 10.4.0.2 this is no longer possible and gives the error, that the command is only possible in support mode. 

Support mode can nly be enabled by TAC because you need an HPE mail to create the support token. 

On 9240 gateways running 10.4.0.2 this command still works.

What is the correct way to read these information on 9012?

------------------------------
Thanks,
Bjarne
------------------------------