You cannot 'flash' an US accesspoint to RW. Trying to do so may make the AP unrecoverable and violates radio regulations.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your HPE Aruba Networking partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact HPE Aruba Networking TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or HPE Aruba Networking.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Feb 10, 2025 08:38 PM
From: thinhvh
Subject: AP 203RP does not work after factory reset
I have old 203RP with US regional. I try to flash it to RW version with console cable. However before reset the AP, I put command factory_reset in putty then the AP boot but cannot get IP from DHCP. How can I recover it? Thx U