Wireless Access

Quick question as the 580 series install guide does not mention this. These new APs provisioned are showing their LED status as green with a quick off every couple of seconds.

It reminds me of some older APs which would do this if they were connected at 100mb.

PoE is delivering 45w and ports are properly connecting at 1000mb.

Any ideas?

Quick question as the 580 series install guide does not mention this. These new APs provisioned are showing their LED status as green with a quick off every couple of seconds.

It reminds me of some older APs which would do this if they were connected at 100mb.

PoE is delivering 45w and ports are properly connecting at 1000mb.

Any ideas?

As noted, this LED indicator isn't documented in the installation guide, I think that will be fixed in the future.

Green LED with pattern of 2.5 seconds on, 0.5 seconds off, indicates a fault on radio 0.  That may be configuration, DRT, assigned regulatory domain, or failed hardware.

Quick question as the 580 series install guide does not mention this. These new APs provisioned are showing their LED status as green with a quick off every couple of seconds.

It reminds me of some older APs which would do this if they were connected at 100mb.

PoE is delivering 45w and ports are properly connecting at 1000mb.

Any ideas?