Hi Pavel, if the switch performs the boot process correctly using the WC.16.10.0016 from the Secondary Software Image and then you recognize just one (or few) physical ports with the reported self test failure message, I suggest you to grab the whole output of the
show tech all CLI command and then contact Aruba by opening a Support Ticket (via the Aruba ASP). Probably your switch is faulty if it is capable to boot flawlessly (otherwise try to boot from the Primary Software image if the booted one is corrupt).
See also
here, note the suggestion: "
If the switch will boot, gather a "show tech all" and review the logs to see what error is reported in the event log. These normally coincide with the fault LEDs on the switch. Use this data to determine what is causing the failure."
BUT...I found this on a old Release Notes:
You didn't tell us the involved port is equipped with a Transceiver (unsupported?).
Please report the output of
show tech transceivers too.
------------------------------
Davide Poletto
------------------------------
Original Message:
Sent: Aug 31, 2021 07:21 AM
From: Pavel Lopushansky
Subject: Aruba 2930F-48G-4SFP Switch (JL260A) ERR 10110060
Hi all,
can you please help me with the error on my Aruba 2930F-48G-4SFP Switch (JL260A).
| Primary Software |
WC.16.10.0016 |
| Secondary Software |
WC.16.10.0016 (Booted) |
| ROM |
WC.16.01.0008 |
I have warning massage - port XX self test failure ERR: 10110060
Unfortunately I could not find any information on this error code.
------------------------------
Pavel Lopushansky
------------------------------