sorry, This guide is from iap, i am ac+ap,I want to understand the ac+ap way,
I tested 1 portal and 1 point, this is no problem, but when adding a point, this point will only connect to the portal, not to the point.
this way of deployment：
------------------------------
leo ma
------------------------------
Original Message:
Sent: Jul 11, 2022 07:05 AM
From: Ariya Parsamanesh
Subject: aruba controller mesh ap multi hop problem
no it is not automatic, in either way it is better to make it predictable.
check this technote that could give you ideas how to ensure the mesh point only connects to mesh portal of your choice.
https://community.arubanetworks.com/community-home/digestviewer/viewthread?GroupId=13&MessageKey=3f3e4689-4dee-497f-aed5-6e6d5cf995da
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Jul 11, 2022 04:42 AM
From: zhipeng ma
Subject: aruba controller mesh ap multi hop problem
dear ariyap
Is there automatic networking between point and point?
------------------------------
leo ma
Original Message:
Sent: Jul 03, 2022 09:25 PM
From: Ariya Parsamanesh
Subject: aruba controller mesh ap multi hop problem
here are the guidelines. In an Instant mesh network, the maximum- Hop count is 2,
- Number of mesh points per mesh portal is 8.
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Jun 28, 2022 09:59 AM
From: zhipeng ma
Subject: aruba controller mesh ap multi hop problem
dear team
i want config mesh multi hop ap， 1 mesh portal ，4 mesh point ，
this is topology，Is the point automatically connected to other points? Do I need to do other configuration?
------------------------------
leo ma
------------------------------