Wired Intelligent Edge

 View Only
  • 1.  Boot Image Secondary Flash - ProCurve Switch 2610-48

    Posted Feb 15, 2011 10:11 AM

    Hi,

     

    I have a problem with my Procurve 2610-48 switch.  Primary flash is older image whereas Secondary flash is newer image.  I have enter "boot system flash secondary", save the config and reload the switch.  The switch boot up with newer image.

     

    However, why does my Procurve 2610-48 switch boot into the primary flash image after I lose power to the switch?

     

    Thanks in advance.

     

    Kenny

     

    P.S. This thread has been moved from  Legacy to ProCurve / ProVision-Based. -HP Forum Moderator



  • 2.  RE: Boot Image Secondary Flash - ProCurve Switch 2610-48

    Posted Feb 17, 2011 11:38 AM
    The Primary flash is the default storage location where the switch will boot from following a switch reset, loss of power, I believe you can change that by enterring config mode and give the command: startup-default secondary
    save and give it a try.


  • 3.  RE: Boot Image Secondary Flash - ProCurve Switch 2610-48

    Posted Apr 02, 2013 03:57 AM

    Yea ....

     

    startup-default secondary

     

    resolves the issue.



  • 4.  RE: Boot Image Secondary Flash - ProCurve Switch 2610-48

    Posted Sep 09, 2013 05:53 AM

     

    Hi there,

     

    i am new to working with HP products.

     

    i recently updated a hp switch from version r_11_30 to R_11_54. 

     

    is if possible to revert it back. to the old version i have tried copying the old os back to the switch but both the primary ands secondary Flash still report the same versions of r_11_54.swi

     

    am i missing something out here can these switches not be down graded?

     

    thanks in advance.

     



  • 5.  RE: Boot Image Secondary Flash - ProCurve Switch 2610-48

    Posted Aug 07, 2014 07:35 AM

    Hey All,

     

    Old post but i felt like replying.

     

    HP has the tendency to change command behavior betweens procurve switch models and firmware's

    Currently a 2610-48 running firmware  11.107 will no longer accept the startup-default command to change default firmware to boot.

    In fact i cant find any command to change the default firmware boot option.

    Startup-default is now only a command to change the default configuration file to use for each firmware.

    Reading trough the 2610 manual leeds me to believe its not possible to (permanantly) change the default firmware boot.

    so in case of power failure primairy flash firmware will always be loaded.

     

    A 2910-al with firmware K15.12.0015 now has 2 commands

    again the startup-default for changing the configuration files to use.

    and a new option in the boot command (for me) :

     

    boot set-default flash primary/secondary

     

    also the show flash commands give slightly different outputs which is very easy to miss:

    for example.

    show flash for 2610 will show the "current boot"

    show flash for 2910 will show the "default-boot"

     

     

    RayMK

     

    Yes it is not a problem to replace the newer firmware with older firmware.

    I bet you already found a way to do that.

    If not and still need to know, leave a message.

     

    regards,

    Ton