Wireless Access

 View Only
Back to discussions
Expand all | Collapse all

Clients in Bridge Mode not Populating Dashboard

This thread has been viewed 1 times

  • 1.  Clients in Bridge Mode not Populating Dashboard

    Posted Sep 01, 2014 05:06 AM

    Morning,

     

    Last week I migrated our London office onto our mobility controller which is based in the North of England via the corporate WAN. All AP's in London are Campus AP's in Bridge mode, everything is working fine (SSID's, 802.1x etc), however we notice that clients in London do not populate the dashboard clients section with their hostname or IP address, they do however populate the 'monitoring' section, please see below image:

     

    Capture.PNG

     

    We are currently using image 6.3.1.2

     

    Can anyone advise if this is a known issue, or a more fundamental configuration error?

    Many thank,

     

    Darren

     



  • 2.  RE: Clients in Bridge Mode not Populating Dashboard

    Posted Sep 02, 2014 10:00 AM

    I am not sure if this is fixed in a later patch but we are now on 6.3.1.10.  Could you consider upgrading to try it out?  If not, please open a support case. 



Related Content