Controllerless Networks

Hi there,

When I run show clients on my Instant deployment it will show not only the connected devices but also the ones that already disconnected.

The UI interface also shows all the clients, even the ones that are disconnected.

But if I run show ap debug client-table only connected devices show.

I would expect the "Clients" tab of the UI to only show users that are effectively connected, so is what I'm seeing normal?

Thanks

It depends on the way clients disconnect, some of them will then rely on idle timeout to be flushed out of the user-table.

Hi there,

When I run show clients on my Instant deployment it will show not only the connected devices but also the ones that already disconnected.

The UI interface also shows all the clients, even the ones that are disconnected.

But if I run show ap debug client-table only connected devices show.

I would expect the "Clients" tab of the UI to only show users that are effectively connected, so is what I'm seeing normal?

Thanks

Uhmm,

Then maybe there is some bug with 8.10.0.12.

Because even when clients cleanly disconnect I see them still in the client list but not on the user-table.

Also, even though clients show in the clients table, I cant run "show client status mac" for those that are disconnected.

It depends on the way clients disconnect, some of them will then rely on idle timeout to be flushed out of the user-table.

Hi there,

When I run show clients on my Instant deployment it will show not only the connected devices but also the ones that already disconnected.

The UI interface also shows all the clients, even the ones that are disconnected.

But if I run show ap debug client-table only connected devices show.

I would expect the "Clients" tab of the UI to only show users that are effectively connected, so is what I'm seeing normal?

Thanks

do these clients connect to PSK or dot1x WLANs? if dot1x, are you using RADIUS Accounting for it?

Uhmm,

Then maybe there is some bug with 8.10.0.12.

Because even when clients cleanly disconnect I see them still in the client list but not on the user-table.

Also, even though clients show in the clients table, I cant run "show client status mac" for those that are disconnected.

It depends on the way clients disconnect, some of them will then rely on idle timeout to be flushed out of the user-table.

Hi there,

When I run show clients on my Instant deployment it will show not only the connected devices but also the ones that already disconnected.

The UI interface also shows all the clients, even the ones that are disconnected.

But if I run show ap debug client-table only connected devices show.

I would expect the "Clients" tab of the UI to only show users that are effectively connected, so is what I'm seeing normal?

Thanks