I believe it is just the config ID the system uses to say that it needs to check and download configuration updates. I have seen this when setting up a controller for the first time with a Mobility Conductor.
------------------------------
Dustin Burns
Lead Mobility Engineer @Worldcom Exchange, Inc.
ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2022-2023
If my post was useful accept solution and/or give kudos
------------------------------
Original Message:
Sent: Mar 06, 2023 01:10 PM
From: McBehr
Subject: Configuration IDs
Going through some logs and found an entry stating "Setting CFGID to -1 (full sync)".
What is -1 for the ID? Does that indicate anything in particular?
This happened when an MD switched to its secondary Conductor due to not receiving heartbeats from the Primary for 15+ minutes.