I found out that I was missing the SNMP community string at the end of the command after the OID part "community ???". I also used public as a community string for testing and was able to run the command. Thanks for the help!
Original Message:
Sent: Feb 04, 2025 08:46 AM
From: JL24
Subject: CX-6100 SNMPWALK command not working
Oh and another thing: On top of running snmp-server you need also proper community name there in command!
------------------------------
Jori Luoto
AV-IT Specialist
Original Message:
Sent: Feb 04, 2025 08:43 AM
From: JL24
Subject: CX-6100 SNMPWALK command not working
Hello,
Do you have snmp server enable in switch?
(cli: snmp-server vrf default)
------------------------------
Jori Luoto
AV-IT Specialist
Original Message:
Sent: Jan 30, 2025 11:37 AM
From: charles470
Subject: CX-6100 SNMPWALK command not working
Hi, so I am trying to run "diag utilities snmpwalk oid ifdescr" on a CX-6100 and I get the error, "Timeout: No Response from localhost." I have tried a couple other OIDs derived from MIB files I found for the CX, but they keep returning the same error. I am not sure if there is anything else that needs to be configured or if it just not supported for this switch.
Firmware: PL.10.13.1040
Model: JL675A
Any help is greatly appreciated.