Wired Intelligent Edge

 View Only

  • 1.  CX questions / improvement

    Posted Aug 17, 2021 06:59 AM
    Edited by Whitehawk29FR Aug 20, 2021 05:33 AM
    Hi,

    Some questions / improvement on CX :

    VSF stacking led member
    I don't know if this is only with the 10.08 release, but when you press the button on "Stk", all ports "1" are blinking on the stack so we don't know which switch is number 1/2/3 etc in the stack .. not practical

    Still no "show interface description"
    -> please Aruba could you add this standard command ?

    Disable HTTP 80
    Can we directly disable http port 80 (keep only https for rest API) on the switch without block port 80 on the control-plane ACL ?

    Control plane ACL logging
    Why does the control plane ACL doesn't log packet drop ? Again not very practical ..

    VSX keepalive :
    Possibility to use the mgmt port instead of an SFP port like we can do on a VSF stack for split detection?

    Thank you !

    ------------------------------
    Laurent from Brest / France
    Network Engineer
    ------------------------------


  • 2.  RE: CX questions / improvement

    Posted Aug 18, 2021 07:43 AM
    On

    Control plane ACL logging
    Why does the control plane ACL doesn't log packet drop ? Again not very practical ..

    I am with you bro! I know what you are feeling ;) In our deployments we need to log acl deny's to our SIEM and it is frustratingly not supported.

    Back in june '21 i logged a feature request with Aruba but shame to see it has not come through yet. I suggest you log a feature request too, the more the better!
    Original Message


  • 3.  RE: CX questions / improvement

    Posted Aug 19, 2021 04:09 AM

    Scheduled reload? is there a CX equivalent?
    Original Message


  • 4.  RE: CX questions / improvement

    Posted Aug 19, 2021 06:08 AM
    Edited by Whitehawk29FR Aug 19, 2021 06:09 AM
    There is a job scheduler since 10.08 but I don't see how to schedule.. 10.08 CLI document is not released yet.

    6300CX(config)# job reboot_at_7am
6300CX(config-job-reboot_at_7am)# 
  <1-4294967295>  Specify the sequence number for the command 
  cli             Specifies the job type as CLI commands 
  delay           Specify the delay to wait before this command execution. The 
                  cumulative delay of all the commands per job should be less 
                  than 300. Default: no delay 
  desc            Job description 
  enable          Enable the job 
  end             End current mode and change to enable mode. 
  exit            Exit current mode and change to previous mode 
  help            Description of the interactive help system 
  list            Print command list 
  no              Negate a command or set its defaults 
  resequence      Renumber job sequence 
  show            Show running system information 
6300CX(config-job-reboot_at_7am)# cli boot system primary​


    6300CX# show job

Job Name : reboot_at_7am

Enabled : Yes
Description :
Status : waiting
Number of commands : 1
Total execution count : 0
Failed execution count : 0

Job CLI commands
----------------
10 cli boot system primary​


    ------------------------------
    Laurent from Brest / France
    Network Engineer
    ------------------------------

    Original Message


Related Content