Wireless Access

 View Only
last person joined: 23 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Expand all | Collapse all

Detect and Protect Wifi Bridge

This thread has been viewed 7 times
  • 1.  Detect and Protect Wifi Bridge

    Posted 15 days ago

    Hi everyone.

    I have Mobility Conductor and Airewave.
     
    I want to detect and block Wifi bridge devices.
     
    I configured like this, but it doesn't work.
     
    Hope everyone can help with this installation and if the Wifi bridge is discovered, where will it be reported?






  • 2.  RE: Detect and Protect Wifi Bridge

    EMPLOYEE
    Posted 13 days ago

    It should show up in the logging or controller dashboard at least, and I'd suppose in Airwave as well but I don't have an Airwave to validate that.

    Here is the documentation for the Wireless IDS/IPS.

    Note that the Wireless Bridge detection relies on the client MAC address to be bridged (seen both to the network and between the bridge and the client). If you have a travel-router, that performs NAT and does not bridge traffic; so won't be detected by that signature.



    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------