It should show up in the logging or controller dashboard at least, and I'd suppose in Airwave as well but I don't have an Airwave to validate that.
Here is the documentation for the Wireless IDS/IPS.
Note that the Wireless Bridge detection relies on the client MAC address to be bridged (seen both to the network and between the bridge and the client). If you have a travel-router, that performs NAT and does not bridge traffic; so won't be detected by that signature.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Jul 08, 2024 06:55 AM
From: phancuong3812
Subject: Detect and Protect Wifi Bridge
Hi everyone.
I have Mobility Conductor and Airewave.
I want to detect and block Wifi bridge devices.
I configured like this, but it doesn't work.
Hope everyone can help with this installation and if the Wifi bridge is discovered, where will it be reported?