Adding additional switches and was testing the Fan preferred direction command on new switch so I can confirm what to apply to existing switches (Changing fans and direction)..Issue is, additional switch only shows slot 3? There are no Slot and Slot 2 and when I attempt to apply command in test I get the following:
The exact issue is I want to change fan direction on existing switches after I replace the fans.
Do I just remove the following commands on existing switches, save the config and power off and install the fans? # fan prefer-direction slot 1 port-to-power fan prefer-direction slot 2 port-to-power
Or do I have to change to?
fan prefer-direction slot 1 power-to-port fan prefer-direction slot 2 power-to-port
© Copyright 2023 Hewlett Packard Enterprise Development LPAll Rights Reserved.