If you have multiple instant APs, you should upgrade the full cluster through the virtual-controller. Easiest is to connect with the webui and you are redirected to the VC/conductor, run the upgrade from there.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your HPE Aruba Networking partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact HPE Aruba Networking TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or HPE Aruba Networking.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Mar 18, 2025 03:29 AM
From: qwa3
Subject: How can I upgrade image of aruba ap615?
hello.
I would like to upgrade image of aruba ap 615 by CLI.
However when I use #upgrade-image command, this comment "We could only upgrade image via conductor" is back.
Can I upgrade image by CLI without conductor?