Did you check that cable is also supported on server NIC?
DAC cables are very tricky for switch to server connection. It need to be supported on both sides and that is not a given.
Best, Gorazd
------------------------------
Gorazd Kikelj
MVP Expert 2023
------------------------------
Original Message:
Sent: Sep 06, 2023 12:44 PM
From: pilgrimage
Subject: HP Aruba 2930f 50 and 52 SFP+ Ports do not work with Dac Cable.
J9283D-SN
10G SFP+ to SFP+ DAC 3M passive
Model : Stornet
Transceiver Technical Information:
Port # | Type | Prod # | Serial # | Part #
-------+-----------+------------+------------------+----------
49 | SFP+SR | J9150D | HPS31N50126 | 1990-4391
51 | SFP+SR | J9150D | HPS31N50123 | 1990-4391
52 | SFP+SR | J9150D | 2101060050 | 1990-4391
Original Message:
Sent: Sep 06, 2023 10:47 AM
From: pilgrimage
Subject: HP Aruba 2930f 50 and 52 SFP+ Ports do not work with Dac Cable.
Hello, I am trying to set up HP Aruba 2930F switch from scratch. However, I noticed some things while setting it up. When I make a connection between the server with the dac cable to the 4 SFP+ ports, especially to the 50 port, the ethernet status drops down after the ethernet status is up. When I connect the same dac cable to port 52, it goes up, then it goes down, then it goes up again, then it goes down again and in sh logging it says something like this;
" FFI : Port: 52 Excessive link state transitions "
However, when I connect with Fiber cable after installing 10Gb gbic for Normal Uplink, 50 and 52 Ports work fine. Do I need to make any settings on the Hp Aruba 2930f especially for it to work with DAC Cable. DAC Cable goes up on ports 49 and 51 without any problem.
thankyou for support.