Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

IAP: AP names not listed in config and how to change ap name via CLI

This thread has been viewed 5 times

  • 1.  IAP: AP names not listed in config and how to change ap name via CLI

    Posted May 29, 2024 05:48 AM

    Hi,

    I have a couple of IAPs 505 with version 8.10.0.12. I know I can configure the AP names via the webgui, however when I look at the cli (show run) the ap names are not listed there. Where are the stored/saved? Also I didn´t found any possibility to change the names of the APs via CLI. Isn´t that possible?

    Any hint appreciated.

    Thanks.



    ------------------------------
    Regards
    Martin
    ------------------------------


  • 2.  RE: IAP: AP names not listed in config and how to change ap name via CLI

     
    Posted May 29, 2024 12:05 PM

    https://www.arubanetworks.com/techdocs/CLI-Bank/Content/instant/name.htm

    name <>  - Name for specific AP

    hostname <> - Hostname for VC



    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    HPE Design and Deploy Guides: https://community.arubanetworks.com/support/migrated-knowledge-base?attachments=&communitykey=dcc83c62-1a3a-4dd8-94dc-92968ea6fff1&pageindex=0&pagesize=12&search=&sort=most_recent&viewtype=card
    ------------------------------

    Original Message


  • 3.  RE: IAP: AP names not listed in config and how to change ap name via CLI

    Posted May 31, 2024 04:16 AM

    'hostname' is not a valid command on (my) instant APs

    'name' sets only the name of the VC



    ------------------------------
    Regards
    Martin
    ------------------------------

    Original Message