Controllerless Networks

Hi, Folks

I have Instant IAP505 running with 8.10.0.13_90226 LSR. The AP is the first AP of cluster. Broadcast one SSID and the client can get the IP(100.100.100.10) via the SSID then reach out to the Internet. But the client can't access to the virtual controller GUI with AP's IP(101.101.101.6). But if the client get the IP address via wired in the subnet(100.100.100.11), the virtall controller accessible.

It's confirmed that there is no firewall, ACL or limited between these two subnets.

Is there any configuration need to be done for the wireless management?

BR

by default there is no especial config. but you can restrict it,

------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------

Original Message:
Sent: May 09, 2025 04:38 AM
From: Jiahao Xu
Subject: Instant AP can't be managed by wireless client

Hi, Folks

I have Instant IAP505 running with 8.10.0.13_90226 LSR. The AP is the first AP of cluster. Broadcast one SSID and the client can get the IP(100.100.100.10) via the SSID then reach out to the Internet. But the client can't access to the virtual controller GUI with AP's IP(101.101.101.6). But if the client get the IP address via wired in the subnet(100.100.100.11), the virtall controller accessible.

It's confirmed that there is no firewall, ACL or limited between these two subnets.

Is there any configuration need to be done for the wireless management?

BR