I am sure I am simply missing a step or reading the instructions incorrectly. Here is my issue.
I have an Aruba 5406r . I want to set up a couple of monitoring sessions. I understand I can set up 1 - 4 sessions. I create the first session and assign an exit port.
I can then run the command "show monitor" and it appears fine. I can then assign an interface and when I run "show monitor 1" I see the Mirror Destination (exit port) and the Monitoring Source. All is good.
I then add a second session and "show monitor".
I can see session 1 is active and it has single source. Session 2 shows inactive and no source. All is as I expect.
Here is the problem . How do I assign an interface to Session2?
If I create the new session 2 and then immediately assign an interface, it always is assigned to session 1 and its exit port. So when I click show monitor, session 1 shows 2 sources and session 2 is still inactive with 0 sources..
I do not know what command assigns the interface to a specific session. It always defaults to session 1 and I cannot find away to get around this.
Thanks
Peter