Wireless Access

 View Only

  • 1.  Mobility Conductor L3 Redundancy

    Posted Aug 23, 2022 05:20 PM
    Hoping for some guidance on Mobility Conductor L3 Redundancy. Currently we have a pair of Mobility Conductors at one of our datacenters with L2 redundancy but want to setup another pair at a separate datacenter. Is it possible to add L3 redundancy to another pair like this? Will licensing for my AP/Controllers fail over?

    I think this can be done and but what would the config look like to a pair rather than a single L3 Conductor at the other DC? Do I just setup the other two MCs as L2 redundancy then do the following on the main MC's of each?

    Primary MC?
    Master-l3redundancy
    L3-sync-state primary (MC1)
    L3-sync-time 1 (hourly)
    L3-peer-ip-address IP ipsec KEY

    Secondary MC?
    Master-l3redundancy
    L3-sync-state secondary (MC1)
    L3-sync-time 1 (hourly)
    L3-peer-ip-address IP ipsec KEY


  • 2.  RE: Mobility Conductor L3 Redundancy

    Posted Aug 23, 2022 06:23 PM
    I would start with a single L3 redundant MM at the backup site.  Details on how someone actually set this up, along with some pitfalls is here:  https://community.arubanetworks.com/community-home/digestviewer/viewthread?MID=17533

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    HPE Design and Deploy Guides: https://community.arubanetworks.com/support/migrated-knowledge-base?attachments=&communitykey=dcc83c62-1a3a-4dd8-94dc-92968ea6fff1&pageindex=0&pagesize=12&search=&sort=most_recent&viewtype=card
    ------------------------------

    Original Message


Related Content