Wired Intelligent Edge

 View Only

  • 1.  NAT on Aruba 8360

    Posted May 07, 2025 08:24 AM
    Hi Community,
     
    We've recently begun integrating Aruba switches into our network and are currently exploring the available features.
     
    I'm looking to implement NAT (Network Address Translation) to translate multiple internal subnets to a single IP address for traffic traversing both LAN and WAN. However, I'm encountering challenges configuring NAT on the Aruba 8360 switch as I cannot find CLI commands. 
     
    Could anyone please confirm whether NAT is supported on this switch series? If so, I'd greatly appreciate it if you could share the relevant CLI commands or configuration guidance.
     
    Thank you in advance for your assistance.
    Regards,
    Ahmed


  • 2.  RE: NAT on Aruba 8360
    Best Answer

    Posted May 07, 2025 08:37 AM
    Hello, NAT is not a supported feature on various Aruba CX 8000 series (say 8100/8320/8360/8325/8400). The NAT capability is (typically) often - if not always - found on networking devices like pure/dedicated Routers or Firewalls...less often found on DC Switches (apart very specific corner cases).



    Original Message


  • 3.  RE: NAT on Aruba 8360

    Posted May 07, 2025 08:42 AM

    Ooh Okay. Thanks for your quick response. 


    Original Message


Related Content