check the getting Aruba Central getting started guide for CX switches
that supports
- Provisioning Factory Default AOS-CX Switches
- Provisioning Pre-Configured AOS-CX Switches
- Monitoring-Only Mode for AOS-CX Switches
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------
Original Message:
Sent: Nov 14, 2023 01:11 AM
From: dpjw36
Subject: Onboarding brownfield devices to Aruba Central
Hi Ariya,
Yes. For Aruba CX switches
Original Message:
Sent: Nov 14, 2023 12:39 AM
From: ariyap
Subject: Onboarding brownfield devices to Aruba Central
is this about Aruba CX switches?
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
Original Message:
Sent: Nov 13, 2023 11:13 AM
From: dpjw36
Subject: Onboarding brownfield devices to Aruba Central
Hi all,
I have few queries regarding Aruba Central. In a brownfield deployment, can I onboard those devices that was configured manually using CLI initially (Day-0 & 1) and then continue to configure them using Central in the future for Day-2 deployment?
If yes, is it using the Central UI or template group?
If the onboarded devices are in monitor mode initially, can I convert them to managed mode without impacting the configuration?