Comware

 View Only
  • 1.  POE PSE State is off on A5120-EI POE Switch

    Posted Nov 02, 2012 11:53 AM

    I have a A5120-EI POE Switch with 4 in a stack.  2 of 4 switches are delivering power
    to VoIP phones however 2 are not.

     

    [FWRI-RMI1-1]display poe device
     PSE ID  SlotNo SubSNo PortNum  MaxPower(W)  State  Model
     4           1           0            48              370                    on       PD67124
     7           2           0            48              370                    off     PD67124
     10        3           0             48              370                   on       PD67124
     13        4           0             48              370                   off     PD67124


    How do I change the PSE State to on?



  • 2.  RE: POE PSE State is off on A5120-EI POE Switch

    Posted Nov 03, 2012 03:28 PM

    [Switch] interface x/x/x

    [Switch-GigabitEthernetx/x/x] poe enable

    PoE on Comware is disabled by default, and must enabled per port.

    hth...Jeff

    PS:
    Another good source of info, the HP Networking and Cisco CLI Reference Guide. A free CLI ref of ProVision, Comware5, and Cisco in side-by-side comparison. Not all inclusive, but alot of the "daily" config needs.  ....and it's free!

    Also good if you have a single platform :-)

    https://h30590.www3.hp.com/product/HP+Networking+and+Cisco+CLI+Reference+Guide-PDF-6997



  • 3.  RE: POE PSE State is off on A5120-EI POE Switch

    Posted Dec 06, 2017 01:55 AM

    I believe the state transfers to on as soon as both of following conditions are met:

    1.- you enabled poe on the interfaces

    2.- you have a poe device connected to an interface of that irf member.