I think you need to change the forward mode on your wired AP profile to tunneled to cross the mesh.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Nov 21, 2023 02:10 PM
From: NickMtz
Subject: Point-to-Point Deployment with AOS 8 and 577 outdoor AP's
This information has been very helpful, thank you. But I think i'm stuck here. I can get the AP's to mesh, and in the controller I see both AP's online. The far ap (.91) is seen as up on my controller. But, when I try to configure and ping the managment interface on my far switch 68.3, i'm unable to ping the interface. I think my config on the Wired AP Profile is incorrect. Please advise.
VLAN 68 is switch Management
VLAN496 is AP VLAN
Switch port interface config:
Interface where AP's .90 and .91 are connected
Mobile1 switch 10.0.68.2
interface 8
name "10.110.96.90"
power-over-ethernet critical
poe-allocate-by class
tagged vlan 68,496
device-type network-device
Mobile 2 switch 10.0.68.3
interface 8
name "AP 10.110.96.91"
power-over-ethernet critical
poe-allocate-by class
tagged vlan 68,496
device-type network-device
Original Message:
Sent: Nov 21, 2023 03:26 AM
From: Stefan Bartels
Subject: Point-to-Point Deployment with AOS 8 and 577 outdoor AP's
Hi,
there are a lot of guides to find.
https://community.arubanetworks.com/discussion/howto-point-to-point-mesh-on-aos-85
https://www.arubanetworks.com/techdocs/ArubaOS_8.10.0_Web_Help/Content/arubaos-solutions/mesh/mesh-depl-solu.htm?Highlight=mesh
https://artofrf.com/2022/05/16/aruba-p2p-mesh-aos8/
Original Message:
Sent: Nov 20, 2023 06:42 PM
From: NickMtz
Subject: Point-to-Point Deployment with AOS 8 and 577 outdoor AP's
Hello,
I'm searching for a deployment guide on a PTP setup. I need to extend my network using a PTP bridge (i think). I found some old info for AOS6, but nothing new for AOS8.
Any info is appreciated. Below is the old documentation.
https://www.arubanetworks.com/vrd/OPPDeployAppNote/wwhelp/wwhimpl/js/html/wwhelp.htm
| Arubanetworks | remove preview |
|