Hi, ariyap - a quick question: are you aware of any issues with the 8.7.1.3 firmware version for IAPs? We upgraded to that version from 8.6.0.6 on two of our IAP clusters and almost immediately began receiving thousands of alerts in AirWave of this type:
meshd[6290]: meshd_anulmesh_link_table_check: LINE 2 no
peer MAC
meshd[6290]: meshd_anulmesh_link_table_check: LINE 1
link mode<Bridge> is not WIFI
meshd[6290]: meshd_anulmesh_link_table_check: open
anulmesh link table succeed
The only way I could stop them was to remove the alert trigger from AirWave. Do you happen to know if this a known issue with this firmware version?
Thanks.
jk
------------------------------
Jon Koelker
------------------------------
Original Message:
Sent: Jun 07, 2021 09:53 PM
From: Ariya Parsamanesh
Subject: Recommended IAP firmware version upgrade
go with the latest maintenance release which is 8.7.1.3
here is the release notes
https://support.hpe.com/hpesc/public/docDisplay?docId=a00112378en_us
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Jun 07, 2021 12:30 PM
From: Jon Koelker
Subject: Recommended IAP firmware version upgrade
We have IAP-305, -315 and -365Outdoor access points in our district. All are currently running firmware version 8.6.0.6-8.6.0.6_77124.
We just purchased an AP-577EX and an AP-575EX for one of our buildings. It appears that the minimum firmware version for these if in the 8.7 series, so in order to add them to an existing instant cluster we will need to upgrade the current virtual controller to 8.7.x.x.
Is there a recommended version of 8.7 to go to from 8.6.0.6?
Thanks.
------------------------------
Jon Koelker
------------------------------