Split tunnel uses the IP address of the RAP (usually the IP address that the RAP pulls using DHCP from the local network) to provide NAT services to devices connected to the RAP. You don't NAT DHCP discovery.
Also, the whole point of the RAP is to allow access to a central location via the VPN, you need to have centralized DHCP or control over that DHCP so that routing works properly.
Now, the better question is why do you want to do this? What are you trying to accomplish?
------------------------------
Carson Hulcher, ACEX#110
------------------------------
Original Message:
Sent: Aug 28, 2024 01:57 PM
From: Ronin101
Subject: Remote AP - Local DHCP SErver
Dear Carson,
Why its not possible? we can breakout the local traffic using source nat rules so why not DHCP?
Original Message:
Sent: 8/28/2024 1:04:00 PM
From: chulcher
Subject: RE: Remote AP - Local DHCP SErver
No.
------------------------------
Carson Hulcher, ACEX#110
Original Message:
Sent: Aug 28, 2024 12:49 PM
From: Ronin101
Subject: Remote AP - Local DHCP SErver
Sorry i didn't understand, its not possible to split tunnel local dhcp?
Original Message:
Sent: 8/28/2024 11:58:00 AM
From: chulcher
Subject: RE: Remote AP - Local DHCP SErver
That would be a bridge mode WLAN on the RAP, otherwise the remote DHCP is useless.
------------------------------
Carson Hulcher, ACEX#110
Original Message:
Sent: Aug 28, 2024 08:17 AM
From: Ronin101
Subject: Remote AP - Local DHCP SErver
Dear Experts,
What ACL entry do i need to enter if DHCP server is local in the branch (ISP router)?