Network Management

 View Only
  Thread closed by the administrator, not accepting new replies.

  • 1.  Replace member stack switch 1960

    Posted Oct 30, 2024 10:33 AM
    No replies, thread closed. 
    Hi,

I have a stack of 4 Aruba 1960 48 (jl809a) switches from one of my customers.

Here is the configuration (the unit IDs are all in AUTO).
    

    


One of my switches no longer responds; (member 2 of my stack), I have a 1960 switch (jl809a) in stock, I have to go change it, but I would like to know how to proceed?

My main goal was to save the current configuration of my stack.

Then on the new switch:

Unboxing my new switch.
Connect it to my station.
Update the firmware to the same level as the stack.
Configure my 2 stack ports.
Manually assign id 2 to it.
Save and turn it off.

Then on the old switch, unplug everything, take it out.

On the stack, install my new switch, connect the stack cables and connect it electrically.

and at the end wire my RJ45.

Do you validate?


Thanks

Nicholas


  • 2.  RE: Replace member stack switch 1960

    Posted Oct 30, 2024 10:34 AM
    No replies, thread closed.

    The 1960 is an Instant ON product, and there is a specific forum for Instant ON. Please ask you question there.



    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------

    Original Message


Related Content