It looks like the AP cannot reach the gateway (on it's system IP). If the AP and gateway are in the same network segment, make sure the system IP is set to that VLAN, or that routing from the AP to the system IP is working properly.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Nov 04, 2024 04:05 PM
From: ivan.galan
Subject: SSID with tunnel mode in AOS 10 is just in surviving state or connecting
Hello,
I have 2 APs 515 that have AOS version 10.7.0.1 and a Gateway 9012 with AOS 10.7.0.1, these devices are in the same network segment so they have connectivity between them.
I have created a ssid in tunnel mode but checking the status of the tunnel from any of the APs, it only alternates between surviving and connecting states. I can't figure out why the tunnel can't be established, do you have any suggestions?
Thanks