Wired Intelligent Edge

 View Only

  • 1.  State information: Configuring port ?? AOS-CX

    Posted Oct 06, 2022 03:57 AM
    Hi,

    On my 6100 AOS-CX, I can't find what this status " State information: Configuring port" on my SFP+ port which does not go up.
    (On this port, i have SFP+ SR link on OM3)


    Cheers



  • 2.  RE: State information: Configuring port ?? AOS-CX

    Posted Oct 07, 2022 03:10 AM
    Edited by ulises.cazares Oct 07, 2022 03:11 AM
    Hi, have you tried to invert the LC terminations in that side of the connection? Sometimes they get inverted going out of the Fiber patch panels

    Other thing to check, the other side is 10G too, rigth? That transceiver won't negotiate 1G if the other side is only SFP.

    I hope this helps
    Original Message


  • 3.  RE: State information: Configuring port ?? AOS-CX

    Posted Oct 08, 2022 05:49 AM
    Hi, could you supply the config for the port?
    Also the show interface transceiver output
    And the output to "show system interface"

    I can't find this on any port on my estate, or in any document. My best guess is the switch doesn't like the config for some reason. For example an interface with a 10G transceiver but the port configured as 25G (default)
    Original Message


  • 4.  RE: State information: Configuring port ?? AOS-CX

    Posted Jun 14, 2024 07:42 AM

    Hi, sorry but did you solve that situation? Today I encounter that problem and I can't find no more information but this thread


    Original Message


  • 5.  RE: State information: Configuring port ?? AOS-CX

    Posted Jun 14, 2024 07:51 AM

    Hi,

    Resolved

    Defective SFP or reboot of the switch. I do not remember.


    Original Message


Related Content