Network Management

 View Only
Back to discussions
Expand all | Collapse all

Static route not shown in "sh IP Route"

This thread has been viewed 5 times

  • 1.  Static route not shown in "sh IP Route"

    Posted Jul 15, 2020 05:24 AM

    I have two Aruba 2930F configured as Core switches with VRRP.

    One the master I'm able to add a static route 0.0.0.0 0.0.0.0 10.15.101.251 and it is shown with the command "sh ip route".

     

    On the backup I have the same configuration but when i add the static route 0.0.0.0 0.0.0.0 10.15.101.251 it is saved in the configuration but it will not be shown with the command "sh ip route"

    Also when i try to ping an ip address from backup to master, for example vlan 25 (x.x.x.254) i got the message "destination not reachable".

    It looks like if the backup don't have a default gateway or route to the master.

     

    Between the master a lacp trunk is created, with all vlan's tagged.

     

    Does anyone has a solution to this problem?



  • 2.  RE: Static route not shown in "sh IP Route"

    Posted Aug 17, 2020 01:20 PM

    Hi,

     

    did you check if your switch has an IP address in the subnet of the gateway (10.15.101.251) configured? Is the VLAN where this IP address is configured in UP state (=is there port on the switch that belongs to the VLAN and is in UP state)? Did you try to ping the gateway from the switch?

    Because as far as I remember only route entries with L2 reachable gateways are shown in the routing table.



Related Content