Wireless Access

We are on Aruba 8.10.0.13, as we still have some AP-2xx, though we are in the midst of upgrading them to AP-635.

Recently, I was looking at a switch for a non-wifi reason, and I noticed that one of our AP-515s in a multigig port showed a connection speed of only 100Mbps. That case happened to be a cable fault, the brown pair was not connected, but it made me look for a table in our MC (nee MM) that shows the wired port speeds of all APs. So far, no success with the GUI, as it does not seem to be a field in the Access Points table. (I may be mis-remembering, as it has been a few years, but I think the Aruba 6 GUI had a column for this?)

Is there a CLI command to list this? Ideally one that shows all APs, rather than a command that I need to run for each individual AP by name, though I guess either could work.

Thanks,

We are on Aruba 8.10.0.13, as we still have some AP-2xx, though we are in the midst of upgrading them to AP-635.

Recently, I was looking at a switch for a non-wifi reason, and I noticed that one of our AP-515s in a multigig port showed a connection speed of only 100Mbps. That case happened to be a cable fault, the brown pair was not connected, but it made me look for a table in our MC (nee MM) that shows the wired port speeds of all APs. So far, no success with the GUI, as it does not seem to be a field in the Access Points table. (I may be mis-remembering, as it has been a few years, but I think the Aruba 6 GUI had a column for this?)

Is there a CLI command to list this? Ideally one that shows all APs, rather than a command that I need to run for each individual AP by name, though I guess either could work.

Thanks,

Thanks! Looks like the "sh ap debug" commands need to be on the MDs, which makes sense.

We are on Aruba 8.10.0.13, as we still have some AP-2xx, though we are in the midst of upgrading them to AP-635.

Recently, I was looking at a switch for a non-wifi reason, and I noticed that one of our AP-515s in a multigig port showed a connection speed of only 100Mbps. That case happened to be a cable fault, the brown pair was not connected, but it made me look for a table in our MC (nee MM) that shows the wired port speeds of all APs. So far, no success with the GUI, as it does not seem to be a field in the Access Points table. (I may be mis-remembering, as it has been a few years, but I think the Aruba 6 GUI had a column for this?)

Is there a CLI command to list this? Ideally one that shows all APs, rather than a command that I need to run for each individual AP by name, though I guess either could work.

Thanks,