Wired Intelligent Edge

 View Only
Back to discussions
Expand all | Collapse all

The "openflow" command is not work on HP 2920-24 switch

This thread has been viewed 0 times

  • 1.  The "openflow" command is not work on HP 2920-24 switch

    Posted May 21, 2014 09:33 PM

    HI, I want to set up a openflow experiment network. But when I input the commond "openflow enable" in the CLI, the system return the result" invalid input: openflow". The firmware version on the switch is WB15.15. I want to know how to solve this problem? Thanks a lot. 

     

    P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. -HP Forum Moderator



  • 2.  RE: The "openflow" command is not work on HP 2920-24 switch

    Posted May 25, 2014 03:38 PM

    first you need to be in config mode ;-)

     

    2920# configure terminal

     

     from here you can start configuring Openflow

    Openflow

    Openflow instance ... etc etc

     

    after every command you can enter "help" for more information



Related Content