Community Feedback

 View Only
last person joined: 3 days ago 

How is the community doing? Do you have any questions or feedback related for the Airheads Community team? This is the place to let us know.
Back to discussions
Expand all | Collapse all

Transceiver Compatibility with FlexFabric 5945

This thread has been viewed 10 times

  • 1.  Transceiver Compatibility with FlexFabric 5945

    Posted 7 days ago

    Hi,
    We are using H3C-SFP-10G-T-SO modules (either from FS or SolidOptics). These connectors are natively recognized and work properly in the FF5940. However, to make the connectors functional in the FF5945, I need to configure the interface as follows:

    [SW-FF5945-Ten-GigabitEthernet1/1/8] port up-mode

    Is this normal? Is this the correct procedure on the FF5945 to make the transceiver functional?
    Thank you.

    Spec.



  • 2.  RE: Transceiver Compatibility with FlexFabric 5945

    Posted 6 days ago

    RJ45 10G transceivers are not supported on 5945. If you have 1G variant, make sure that is it compatible with JD089B transceiver like https://edgeoptic.com/products/hp/jd089b/.

    You can find transceiver guides in networkingsupport.hpe.com portal. For 10G SFPs here is the link to the guide.

    Best, Gorazd



    ------------------------------
    Gorazd Kikelj
    MVP Guru 2024
    ------------------------------

    Original Message


  • 3.  RE: Transceiver Compatibility with FlexFabric 5945

    Posted 13 hours ago

    I confirm that the transceiver models are defined as compatible.
    During the test I performed on our FlexFabric 5945, the transceiver works properly when we force the port into 'up-mode.'

    However, since I'm not certain if this behavior is normal, I prefer to refrain from using these transceivers on our FlexFabric 5945.


    Original Message