Comware

 View Only
  • 1.  Transceiver Compatibility with FlexFabric 5945

    Posted Sep 30, 2024 11:00 AM

    Hi,
    We are using H3C-SFP-10G-T-SO modules (either from FS or SolidOptics). These connectors are natively recognized and work properly in the FF5940. However, to make the connectors functional in the FF5945, I need to configure the interface as follows:

    [SW-FF5945-Ten-GigabitEthernet1/1/8] port up-mode

    Is this normal? Is this the correct procedure on the FF5945 to make the transceiver functional?
    Thank you.

    Spec.



  • 2.  RE: Transceiver Compatibility with FlexFabric 5945

    Posted Oct 01, 2024 03:47 AM

    RJ45 10G transceivers are not supported on 5945. If you have 1G variant, make sure that is it compatible with JD089B transceiver like https://edgeoptic.com/products/hp/jd089b/.

    You can find transceiver guides in networkingsupport.hpe.com portal. For 10G SFPs here is the link to the guide.

    Best, Gorazd



    ------------------------------
    Gorazd Kikelj
    MVP Guru 2024
    ------------------------------



  • 3.  RE: Transceiver Compatibility with FlexFabric 5945

    Posted Oct 07, 2024 09:33 AM

    I confirm that the transceiver models are defined as compatible.
    During the test I performed on our FlexFabric 5945, the transceiver works properly when we force the port into 'up-mode.'

    However, since I'm not certain if this behavior is normal, I prefer to refrain from using these transceivers on our FlexFabric 5945.