as MKK referenced, it is disabled by default
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------
Original Message:
Sent: Jan 27, 2024 03:24 PM
From: mkk
Subject: Verify and Disable BLE Radios on APs
Hi Michael,
Maybe take a look on this.
https://www.arubanetworks.com/techdocs/ArubaOS_8.11.0_Web_Help/Content/arubaos-solutions/access-points/ble-op-mode.htm
https://www.arubanetworks.com/techdocs/ArubaOS_8.11.0_Web_Help/Content/arubaos-solutions/access-points/conf-ap-syst-prof.htm#APSYSTEMPROFILE
https://www.arubanetworks.com/techdocs/CLI-Bank/Content/aos8/sh-ap-dbg-ble-cn.htm
------------------------------
Marcel Koedijk | MVP Expert 2023 | ACEP | ACMP | ACCP | ACDP | Ekahau ECSE | Not an HPE Employee | Opinions are my own
Original Message:
Sent: Jan 27, 2024 08:41 AM
From: mharing
Subject: Verify and Disable BLE Radios on APs
Hi all,
I'm trying to verify the status of the BLE radios on our access points. I was under the impression these were disabled by default, but in reading some documentation, it's unclear to me if that's the case or not. We're running 8.10.0.6 and I don't see an option for the BLE Operating Mode under the AP System Profile anymore. Is there a way to verify the BLE radios are active and if so, how to go about disabling them now?
Thank you!
------------------------------
Michael Haring
------------------------------