Hello there..
I'm trying to power up a VOIP phone on one of the AP 505H ports, but not sure how to properly configure the Wired Port profile since there is no way to mark a voice vlan.
No matter how I configured the port, the phone is stuck at DHCP Discovery Option 125.
The feed switch port (cisco) is configured with a voice vlan and access vlan. If I plug the phone there, it works, so something is not passing thru.
I tried Trusted on/off, Forward mode tunnel and bridge, Switchport mode access and tunnel, and setting the access mode vlan to the voice vlan. In fact, if I set the access vlan to the voice vlan and connect another device, it properly gets an IP address. I opened up a case with TAC and got some packet captures but I figured I'm not the only one that's ever done this, right? These are Mitel VOIP phones.
Any ideas? TIA.
------------------------------
---
°(((=((===°°°(((=================================
------------------------------