Cloud Managed Networks

 View Only

  • 1.  Webhooks - some alerts do not send State Close

    Posted Jun 07, 2021 10:42 AM
    I've recently setup a webhook with an alerting platform which works fine.
    However, some alerts in Central do not send a "state: Close" when the alert becomes clear.
    An example is "AP Disconnected" or "Aggregate Device Disconnections".

    One alert that does send a "State: Close" is Switch Disconnected.

    Why is this the case?

    Automation is critical and this would seem like a no brainer..

    Thanks in advance for any comments, updates on when it might be available or information to the contrary...

    ------------------------------
    Rory
    ------------------------------


  • 2.  RE: Webhooks - some alerts do not send State Close

    Posted Aug 19, 2021 07:41 PM
    did you get this sorted?

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
    ------------------------------

    Original Message


  • 3.  RE: Webhooks - some alerts do not send State Close

    Posted Aug 25, 2021 06:32 AM
    I think, need to open an issue on TAC...

    ------------------------------
    PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...

    PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)

    PowerArubaCL: Powershell Module to use Aruba Central

    PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..

    ACEP / ACMX #107 / ACDX #1281
    ------------------------------

    Original Message


  • 4.  RE: Webhooks - some alerts do not send State Close

    Posted Aug 26, 2021 05:48 AM
    What's the point? I need to open a new one? why?



    Original Message


Related Content