Wired

 View Only
last person joined: 2 days ago 

Expand all | Collapse all

Which command is used in Aruba 2930 m/f switch again Cisco switch?

This thread has been viewed 9 times
  • 1.  Which command is used in Aruba 2930 m/f switch again Cisco switch?

    Posted Dec 06, 2022 10:58 AM
    interface FastEthernet0/18
    switchport mode access
    authentication order dot1x mab
    authentication priority dot1x mab
    authentication port-control auto
    authentication periodic
    authentication timer reauthenticate server
    mab
    dot1x pae authenticator
    dot1x timeout server-timeout 30
    dot1x timeout tx-period 10
    dot1x max-req 3
    dot1x max-reauth-req 10
    spanning-tree portfast edge


  • 2.  RE: Which command is used in Aruba 2930 m/f switch again Cisco switch?

    MVP GURU
    Posted Dec 06, 2022 06:05 PM
    Have a look at CLI Reference Guide for ArubaOS-CX, ArubaOS-Switch and Cisco IOS (Version 5 - 2019).


  • 3.  RE: Which command is used in Aruba 2930 m/f switch again Cisco switch?

    Posted Dec 07, 2022 12:54 AM
    Yes, I checked, but this is a Cisco port interface configuration.
    please help.


  • 4.  RE: Which command is used in Aruba 2930 m/f switch again Cisco switch?

    EMPLOYEE
    Posted Dec 07, 2022 05:23 AM
    Config looks pretty standard 802.1X + MACAUTH on the port. I would use the config from the ClearPass Wired Enforcement Solution Guide.

    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------