Access Points

Reply
Occasional Contributor II

AP Light-GUI-CL correlation

:confused: I'm sure this is simple, but I can't seem to figure it out. Specific to an AP-105, where in the command line output, and the GUI can I correlate the status of the lights (Particularly the 3rd and 4th lights)?

Example:
11A/N = off
CL = ???
GUI = ???

11A/N = Amber
CL = ???
GUI = ???

etc, etc.

I was trying to find a document to tie all of this together, but no luck.
Guru Elite

Re: AP Light-GUI-CL correlation

I found the attached on the support site (support.arubanetworks.com) under documentation> Hardware> AP> AP105

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: