Access Points

Reply
Contributor I

AP provisioning wih flag I

Hello.

I have an AP-61 that, when provisioning, flag I appears in the controller. I have found throught console that at the end of the provisioning procces an error message is displayed:

............
wifi0: AP type AP-61, radio 0, max_bssids 16
wifi0: Atheros 2313 WiSoC: mem=0xb8500000, irq=5
MTD do_erase_oneblock(): software timeout
# erase err

I have read in another thread about this issue but could not find the solution.

What can I do? Is it a hardware issue?

Regards.


Alejandro
Guru Elite

Re: AP provisioning wih flag I

If this is ArubaOS 6.0.0.0 and above, that could be that control plane security is on and the access points are not allowed. Type "show ap database" and see if there is anything besides the "I" in the flag column.

To make sure control plane security is not the issue, do this:

config t
control-plane-security
auto-cert-allow-all
auto-cert-prov

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Contributor I

Re: AP provisioning wih flag I

I have version 5.0. I did what you said but the problem cotinues.

Regards.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: