Access Points

Frequent Contributor I

ap-150 configure dhcp via console

I provisioned the AP-105 using a 3600 controller with a static ip. It is the wrong IP and now I need to change it back to dhcp. Is there a way I can configure it to use dhcp from the console?
Guru Elite

Re: ap-150 configure dhcp via console

You would do "setenv ". So if I wanted to zero out the static ip address, I would do this:

setenv ipaddr
setenv netmask
setenv gatewayip

Make you do "printenv" to make sure those variables are gone.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
Showing results for 
Search instead for 
Did you mean: