Airheads Volunteer Corps - Support Request

Reply
Highlighted
New Contributor

İAP MESH 303 ?

hi i need help I have two aruba iap 303s and I want to use them to communicate with two PLCs. There will be no internet connection, only data transfer. How should iap settings be? I disabled extended ssid I enabled eth0 bridging for 2.ap(first ap portal second ap point). and I have to give static ip . There will be no gateway. example 192.168.5.10 -255.255.255.0 I need to install virtual control ?, I request your help

Highlighted
MVP

Re: İAP MESH 303 ?

This sounds basically correct.

ensure the wired port profile assigned to the active ethernet ports

is correct with respect to VLANs. Watch carefully for various forms of STP across such a design.

 

I highly prefer the IAPs in the untagged vlan 1 (matching the upstream network PVID) and other traffic carefully tagged.

 

Optimize the channels (avoid DFS channels if possible), disable ARM scanning, usually AP transmit power is set at maximum.

 

 

Shawn Adams
Aruba Networks Customer Advocacy
Highlighted
New Contributor

Re: İAP MESH 303 ?

thanks for your reply. communicates wirelessly, but devices connected via cable cannot access them. How can I make these settings? No light on ap switch with point

Highlighted
New Contributor

Re: İAP MESH 303 ?

How can I communicate two devices connected by cable? Should it be native vlan 3? I would like their help for wired communication settings.

IP address does not exist for virtual controller. ?

 

 

 

 

Current Setup.PNG

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: