ArubaOS and Controllers

Reply
Occasional Contributor II

How to configure many domain configuration ?

I have some question about radius server group.
If I have 2 radius 2 server at 2 domain, how to config to use xxx.com domain user with radius 1 and yyy.com domain user with radius 2.

Because I'm don't sure, I should use authstring, FQDN, Trimming Domain.
And how different for each match type ?

Thank you,
Guru Elite

Re: How to configure many domain configuration ?


I have some question about radius server group.
If I have 2 radius 2 server at 2 domain, how to config to use xxx.com domain user with radius 1 and yyy.com domain user with radius 2.

Because I'm don't sure, I should use authstring, FQDN, Trimming Domain.
And how different for each match type ?

Thank you,




You put both servers in the same server group. If you know that a domain that has "xyz.com" needs to send its authentication to server1, in the server group edit the properties and add a matchstring that has "xyz.com" in it. That way, ONLY requests that have xyz.com in the username will use that server. All other requests will go to the second server."

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: