Aruba Central support mode - config keeps getting overwritten?
06-25-2019 10:27 AM
So I have a stack of 8 2930Fs in Central as a template group. There is a lot to be desired with adding a stack and managing it in any meaningful way, but anyway...
The stack has a template imported, I enabled central support mode on the switch to re-enable to CLI to make some configuration changes since JSON is waay too difficult to manage unless youve been specifically trained.
About an hour or so after adding changes in support mode, the switch keeps reverting to an old config. Is this central doing this? How can it do that when support mode is enabled, I thought that put the entire device in monitor only mode.
Re: Aruba Central support mode - config keeps getting overwritten?
06-25-2019 10:54 AM
Willem Bargeman ACMX#935 | ACCX #822
Please give me kudos if my post was useful!
If your issue is solved mark the post as solution!