Cloud Managed Networks

Reply
Highlighted
New Contributor

Refresh rate for client details in WLC (Default time)

I'm trying to monitor client station parameters for RSSI and SNR while roaming around the floor, but the refresh rate of the information showed by the CLI command "show client detail <MAC>" is too high (30 seconds?) for real-time information.

 

Is it there any command to decrease the refresh rate of that information?

 

Regards

Vignesh J

Highlighted
Guru Elite

Re: Refresh rate for client details in WLC (Default time)

That is because the AP sends RSSI and SNR info to the VC no sooner than every 30 seconds.. 


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Video Knowledge Base
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: